Cisco D9040 User And Service Manual page 72

System Menu,
Continued
Option License, Auto Concatenation
Parameters:
Description:
Option License, AAC, Channel 1, Channel 3, Channel 5 or Channel 7
Parameters:
Description:
Reset
Parameters:
Description:
4-12
Enabled, Disabled
The status of the license signifies the following:
Status Explanation
Enabled The option is present and enabled.
Disabled The option is either disabled or uninstalled. In this case
you have to enable or install the option to make it
work.
Please contact your local Cisco sales representative if
you want to buy an option.
Enabled, Disabled
You need an option license for each of the AAC channels. The status
of the license signifies the following:
Status Explanation
Enabled The option is present and enabled.
Disabled The option is either disabled or uninstalled. In this case
you have to enable or install the option to make it
work.
Please contact your local Cisco sales representative if
you want to buy an option.
N/A
Resets (boots) the D9040 Encoder.
The D9040 Encoder displays a message asking you to confirm the
resetting of the unit. Press SELECT to reset the encoder, or press UP
or PREV to leave the menu without making any changes.
Hint: You should reset the D9040 Encoder if:
• there has been a temperature alarm causing the D9040 Encoder
to disable functionality.
• you have set or changed the IP address, subnet mask or gateway
of one of the IP interfaces of the D9040 Encoder via the front
panel display.
Note: The reset may take up to 120 seconds.
Front Panel Operation
4020024 Rev C