Cisco D9040 User And Service Manual page 50

Overview,
Continued
Connectors
The following table describes the function and type of the various connectors:
Connector
Power
COMPOSITE IN
REF IN
ASI OUT 1
ASI OUT 2
ASI Monitor
ALARM
10/100 BASE-T
MANAGEMENT
STATMUX
ETHERNET 100
BASE-T AUX
ETHERNET 100
BASE-T IP TS OUT
SDI IN
CUE TONE
CONTACT
CLOSURE
DIGITAL AUDIO IN
(1 + 2)
ANALOG AUDIO
IN 1 & 2
ANA/DIG AUDIO
IN 3 + 4
3-6
Function
AC power
Composite input (PAL/NTSC)
Reference input for synchronization
to an external video source.
ASI output. Two identical outputs.
Outputs can be muted.
ASI output. This output cannot be
muted.
Alarm relays
For control and management of local
and remote D9040 Encoder units.
Connection to the Regulus Statistical
Multiplex Controller
Transport stream encapsulated in IP
packets. Used for Backup IP output
or PCR synchronization
Transport stream encapsulated in IP
packets. Used for Main IP output
SDI input
Cue tones for DPI triggering (not
supported in this release)
Contact closure for DPI triggering
Audio mode changes
Digital audio input for channels 1
and 2
Analog audio input for channels 1
and 2
Analog and digital audio input for
channels 3 and 4
Installation
Connector Number
and Type
IEC 60320 Sheet 14
BNC
BNC
BNC
BNC
9-pin sub-D female
RJ45
9-pin sub-D female
RJ45
RJ45
BNC
Terminal block
75 ohm
Terminal block
Terminal block - 75
ohm or 110 ohm
4020024 Rev C