Messages - Cisco D9040 User And Service Manual

Messages

General
The status of the D9040 Encoder and its immediate surroundings is reported to the
PNC in the form of messages and alarms. In the PNC, you can enable or disable
messages and attach an alarm category to each message.
Before You Start
Messages from the D9040 Encoder are shown in the PNC alarm log. For information
on how to view the messages, see the PowerVu Network Centre 8.0 (or later) User's
Guide.
D9040 Encoder Message List
The following shows an alphabetical list of examples of the the available messages,
their default status and an explanation of the messages that can be displayed on the
front panel LCD. For a complete of the available messages, see the PowerVu
Network Centre 8.0 (or later) User's Guide. However, note that the messages may
appear slightly different in the PNC alarm log compared to the D9040 Encoder front
panel LCD.
Message Description and Remedy
A general Description: A general hardware error
hardware error has occurred. Remedy: When persistent,
contact your Cisco technical support
has occurred.
center for repair.
A general Description: A general software error has
software error has occurred. Remedy: If problems are
occurred. observed, reset the encoder. When
persistent, contact your Cisco
technical support center for further
assistance.
All settings were Description: All settings were set to
defaulted. default as a result of a default command.
Remedy: Not applicable.
An option has Description: An installed option license
expired. expired. Remedy: Order the needed
license through your local Cisco
technical support center.
5-8 Service and Maintenance
Severity Default
alarm
category
Critical A
Major B
Information None
Information None
4020024 Rev C
Enable
On
On
On
On