Set Strong Security Mode - Cisco TelePresence MX200 G2 Administrator's Manual

Cisco TelePresence MX200 G2 and MX300 G2

Introduction

Set strong security mode

Sign in to the web interface, navigate to
and open the Strong Security Mode tab.
Set strong security mode
Read carefully about the consequences of strong
security mode before you continue.
1. If you want to use strong security mode, click
Enable strong security mode.... and confirm
your choice in the dialog box that appears.
The video system restarts automatically.
2. Change the passphrase when you are
prompted. The new passphrase must meet the
strict criteria as described.
How to change the system passphrase is
described in the ► Change the system
passphrase chapter.
Return to normal mode
Click Disable strong security mode... in order to
restore the video system to normal mode. Confirm
your choice in the dialog box that appears.
The video system restarts automatically.
D15332.01 MX200 G2 and MX300 G2 Administrator Guide CE8.0, NOVEMBER 2015.
Configuration Configuration
Configuration > Security,
Peripherals Maintenance
28
Administrator Guide
System settings
About strong security mode
Use strong security mode only when
compliance with DoD JITC regulations is
required.
Strong security mode sets very strict
passphrase requirements, and requires all
users to change their passphrase on the
next sign in.
www.cisco.com — Copyright © 2015 Cisco Systems, Inc. All rights reserved.
Appendices