Cisco TelePresence MX200 G2 Administrator's Manual page 55

Cisco TelePresence MX200 G2 and MX300 G2

Introduction
Factory reset the video system
Factory reset using the reset button
We recommend that you back up the log files and configuration of
the video system before you continue with the factory reset.
1. Remove the video system's back cover.
2. Use the tip of a pen (or similar) to press and hold the recessed
reset button until the screen turns black (approximately 10
seconds). Then release the button.
3. Wait while the video system reverts to the default factory
settings. The video system restarts automatically when
finished. This may take a few minutes.
The video system confirms the factory reset by displaying a
notification on the main screen. The notification disappears
after approximately 10 seconds
D15332.01 MX200 G2 and MX300 G2 Administrator Guide CE8.0, NOVEMBER 2015.
Configuration Peripherals
(page 2 of 2)
Maintenance Maintenance
Reset button
The recessed button can be quite
difficult to use. You should feel the
button go down when pushed.
www.cisco.com — Copyright © 2015 Cisco Systems, Inc. All rights reserved.
55
Administrator Guide
System settings Appendices
Lift this handle to lock/unlock
the back cover.
Similar function also on
wheel base, table stand and
wall mount options.