Control The Local Camera(S) - Cisco TelePresence MX200 G2 Administrator's Manual

Cisco TelePresence MX200 G2 and MX300 G2

Introduction

Control the local camera(s)

Sign in to the web interface and navigate to
Prerequisites
• The Video > Input > Connector n > CameraControl >
Mode setting is switched On .
• The camera has pan, tilt or zoom functionality.
Snapshot area
Shows snapshots of the main input source.
Only available on video systems that have the
Remote Monitoring option.
Automatically refresh snapshots
Move the camera using the pan/tilt/zoom controls
1. Click the camera icon to open the camera control
window.
Video snapshots from the room are only displayed for
video systems that have the Remote Monitoring option.
2. Use the left and right arrows to pan the camera; the up
and down arrows to tilt it; and + and
Only relevant controls appear in the window.
D15332.01 MX200 G2 and MX300 G2 Administrator Guide CE8.0, NOVEMBER 2015.
Configuration Peripherals
Call Control.
- to zoom in and out.
Maintenance
Move the camera to a preset position
1. Click
2. Click a preset's name to move the camera to the preset
3. Click
www.cisco.com — Copyright © 2015 Cisco Systems, Inc. All rights reserved.
130
Administrator Guide
System settings Appendices Appendices
Presets... to open a list of available presets.
If no presets are defined, the button is disabled and
named No presets.
position.
OK to close the window.
You cannot use the web interface to define a preset;
you should use the Touch controller.