Honeywell SmartPAC 2 User Manual page 393

SmartPAC 2 with WPC Integration
• If you have two operator stations, the run buttons on one station must be depressed
within 5 seconds of the buttons on the other operator station. The buttons on each
station must be depressed within 0.5 seconds of each other.
4. Hold the buttons down at least until bottom dead center or until the Auto Carry-up angle.
The upstroke is automatic. The ram will stop if any RUN/INCH button is released during
the down stroke before the Auto Carry-up angle, if a system fault is detected, or if the
light curtain is blocked during the down stroke. See the instructions for using Auto
Carry-up, page 235.
SmartPAC 2 Run Mode Chapter 6
1126800
page 371