Honeywell SmartPAC 2 User Manual page 135

SmartPAC 2 with WPC Integration
Determine Top Stop Angle if Press Stopped AFTER TDC
If the press stopped
AFTER TDC
steps below. Refer to the example given.
1. In Run mode, select PRESS CONTROL. Read the value of the Top Stop Angle at the top
of the menu that appears. This will be the "Old Top Stop Angle" in your calculations,
below. Write this value in the box.
Example:
2. Press RESET. In step 4 on page109, you wrote the Average Angle the Press Stopped.
Write this number in the box below. This is where the press actually stopped, and, since
it is after TDC, will be called the "Overshoot Angle."
Example:
TDC
360°
(0°)
Installing SmartPAC 2 and WPC
, find and set the correct Top Stop Angle by following the
°
_
Old Top Stop Angle
__270 ° Old Top Stop Angle
°
Overshoot Angle
Chapter 2
15
° Overshoot Angle
1126800
(Between 0 ° ° ° ° and 180 ° ° ° ° )
page 113