Setting The Other Sensors For The Tool; Going Back To The Main Programming Menu - Honeywell SmartPAC 2 User Manual

SmartPAC 2 with WPC Integration
number of
strokes to set
for green
special sensor
can be from 1
to 99
Figure 5 - 25. Setting "green special" sensor
NOTICE
For more information, refer to the section "Understanding Sensor Technology" in Chapter 1
for a detailed description of the green special sensor and other types of sensors.

Setting the Other Sensors for the Tool

After you make the last setting for the sensor, you will again see this display (Figure 5-10). The
name of your sensor will appear in the display. The next sensor is automatically highlighted.
To set more sensors, select the next sensor from the list and make settings for the sensor.
Make settings in the same way for the rest of the sensors you are using.

Going Back to the Main Programming Menu

When you are done making settings for all sensors and have the list of sensors on your
display, press RESET once more. You will again see the main Tool Program menu
(Figure 5 - 11). You can select tool name, counters, or cam timing and make those settings
for the tool. You can also select "Die Protection" again to display the list of sensors for the
tool and check or change settings.
1. After you change settings for the tool, and the Tool Program menu is on the display, you
can do one of the following:
• Press F4-"Load this Tool" to load the tool (see "Load an Existing Tool," page 278)
or
• Press RESET. One of the following occurs:
• If you press RESET after you edited the tool that is currently loaded, go to the
next step.
• If you press RESET after you edited an existing tool that was not currently
loaded, the Program Mode Main menu appears.
SmartPAC 2 Program Mode
TOOL NUMBER 1234567
CHAIR BRACKET
CRITICAL ANGLE 0
THIS SENSOR MUST TURN ON
AT LEAST ONCE EVERY
USE CURSOR KEYS TO CHANGE # OF STROKES
PRESS THE RESET KEY WHEN YOU ARE DONE
Chapter 5
SENSOR 1
PART EJECTION
GREEN ESTOP
11 STROKES
1126800
page 299