How To Use Hot Keys; Toggle Hot Keys - Honeywell SmartPAC 2 User Manual

SmartPAC 2 with WPC Integration

How to Use Hot Keys

USE THE CURSOR KEYS
TO MAKE SELECTIONS.
PRESS ENTER TO
ACCESS SELECTION.
270
Figure 6 - 5. Run Main Menu, Showing Hot Keys Programmed
In Run mode, Hot keys are function keys that are specially programmed to take you directly
to the screens you want. After you have programmed Hot keys, you can simply press the
F key next to the label describing the screen, and SmartPAC 2 goes to that screen.
Example
You frequently need to adjust the timing for the cam channel that controls part blowoff. For
convenience, you set up a Hot key to take you directly to the cam channel's adjust screen from
the main Run menu.
You can use all the function keys, F1 through F8 as Hot keys, unless you have the bilingual
option, which uses F1 to change languages. You can recognize Hot keys in the main Run
screen by the red frame around their descriptive labels. You can have two sets of Hot keys
(see next section), for a total of sixteen if you do not have the bilingual option.
NOTICE
If you add or remove an option, previously set Hot keys will not navigate correctly. If this
happens, delete and re-program the Hot key or keys that are not working correctly.

Toggle Hot Keys

In the main Run menu, shown in the figure above, the last menu item says "TOGGLE HOT
KEYS 1." When this menu item shows, you can see the first set of Hot keys labels at the
right side of the display, if any are programmed. To access the other set of Hot keys, use the
cursor keys to highlight "TOGGLE HOT KEYS 1." "TOGGLE HOT KEYS 2" appears and
the second set of Hot keys labels also appears. This menu item determines which set of Hot
keys you see. For more information, see "TOGGLE HOT KEYS," page 363.
SmartPAC 2 Run Mode
CAMBIE
AL ESPANOL
VIEW SENSOR
SUMMARY
VIEW GLOBAL
CAM SUMMARY
ENABLE SENSORS
COUNTERS
ADJ SENSOR
CAM SWITCH
PART EJECTION
BRAKE MONITOR
TONNAGE/WAVEFORM
ADJUST CAM
PROCESS MONITOR
SPRAY LUBE
FEED CONTROL
PM MONITOR
TONNAGE
TOOL INFORMATION
PLAN VIEW
SHUTHGT/CNTRBAL
ERROR LOG
DISPLAY
LOAD NEW TOOL
SHUT HEIGHT
DIALOG MENU
TOGGLE HOT KEYS 1
ADJUST
SETPOINTS
Descriptive labels
for Hot keys
Chapter 6
F1
F2
F3
F4
Use F1 - F8 as Hot keys
F5
If you have the Bilingual Option,
F1 is reserved for changing
F6
language and cannot be used
as a Hot key.
F7
F8
1126800
page 327