Installing The Router - Honeywell MDENR100 Installation Manual

LED
Power
LED
Link/Act
Fdx/Col
100
Back Panel
LED
Link
Act
Diag
Port
Internet Port
RESET
LAN Ports
DC Input Port
Caution: Reset Button
Press the Reset button for more than 3 seconds. The router will restore to factory default setting. Note that this
should be done only when you had tried all the troubleshooting options. Pressing the Reset button during
operation may bring you into the risk of creating IP address conflict between your PC and the router. In such a
case, you may be compelled to reboot your entire system(s).

2.2 Installing the Router

This section will discuss what you should do before connecting your router to the network and how to physically
install it. The MDENR100 Cable/DSL Router fits into Quicknetwork panels. The HBENR100 Cable/DSL Router fits
into SuperPro panels.
Table 2-1 POWER Status LED Functionality
Color
Green Lights to indicate the router has power.
Table 2-2 10/100 Port Status LED Functionality
Color
Lights to indicate a functional network link through the
corresponding port with an attached device.
Green
Blinks to indicate that the router is actively sending or receiving
data over that port.
Lights to indicate that the connection made through the
corresponding port is running in Full Duplex mode.
Green
Blinks periodically to indicate that the connection is
experiencing collisions.
Lights for any port to indicate that the port is operating at 100
Mbps.
Orange
Off to indicate that the port is operating at 10 Mbps while the
network is still operating.
Table 2-3 Internet LED Functionality
Color
Lights to indicate a successful connection between the Router
Green
and your broadband device or network.
Blinks to indicate that the Router is sending or receiving data
Green
over the broadband (Internet) port.
Lights to indicate the Router's self-diagnosis mode is running
Red during boot-up and restart. It will turn off when completing the
diagnosis.
Table 2-4 All Port Functionality
This port allows the router to connect to the internet.
Pressing the Reset button for more than 3 seconds to restore to the
factory default setting.
These five network ports connect to network devices such as PCs,
print servers and other network peripherals at 10/100 Mbps.
To connect the adapter to receive power.
Function
Function
Function
Function
-3-