Table of Contents
Advertisement
Figure 3-32 Virtual Server Setting Menu Screen (With WAN Address)
3.5.6 Routing
Static Routing:
You may set up a static route if your want to connect your router to more than one network. A static route is a
pre-determined pathway that network information must travel to reach a specific host or network.
Figure 3-30 shows the screen of Static Routing and Dynamic Routing menu.
Create a Static route entry as follows:
1.Select "Static Routing" from the drop down list.
2.Enter the following data to set the Static Routing:
Destination LAN IP
You can create a static route by entering the IP address of the remote host or network. If you wish to build a
route to the entire network, be sure to set the network portion of the IP address to zero (0).
Subnet Mask
The Subnet Mask determines which portion of an IP address is the network portion, and which portion is the
host portion.
Gateway IP
This is the address of the gateway device that allows for a contact between the Router and the remote
network or host.
-26-
Advertisement
Table of Contents
