Preparing For The Installation; Getting Started - Honeywell MDENR100 Installation Manual

2.2.1 Preparing for Installation
Before you start to connect your router to any network device, make sure you get the following values from your
ISP. You will need those values to setup the Router and configure you networked PCs to accept the IP address
the Router chooses to assign them.
PPPoE User Name and Password
or
Fixed Internet IP Address assigned by your local ISP
Your Subnet Mask
Your Default Gateway
Your Primary DNS IP address
You are supposed to have all those information mentioned above from your ISP. If not, contact your ISP and they
will be able to supply all the information you need.
Note: If you have completed the basic configuration of the router, you may refer to Section 3.6 Configuring your
PCs to connect to the Router to configure the PCs that you plan to connect to the Router.

2.2.2 Getting Started

Follow the steps listed below to install your Router when you have all the information mentioned above on hand.
1. Power all devices down. This should include your PCs, Cable or DSL modem and the Router.
2. Connect the Router to your PCs.
A. Connect one end of a standard network cable to the 10/100 RJ-45 LAN ports on the front of the Router.
B. Connect the other end of the cable to the PC.
3. Connect the Router to your Cable or DSL modem.
A. Connect one end of a standard network cable to the RJ-45 WAN port on the front of the Router.
B. Connect the other end of the cable to either a Cable or DSL modem.
4. Supply the power to the Router.
A. Connect one end of the power cable to the Router.
B. Connect the power cube end of the power cable to a standard wall outlet.
When the router receives power, the Power LED should remain solid Green.
5. Supply the power to either your Cable or DSL modem.
6. Press the Reset button to restore the router's default settings. Hold the button in for three seconds, or until the
Diag LED illuminates red.
-7-