Honeywell ADEMCO 6271 Series Installation And Setup Manual page 60

NIGHT Setup Button Function" in Section 4 of the TouchCenter
Installation and Setup Guide.
• Note that some displays on the TouchCenter may not have enough
space to display the whole name of a partition. When this occurs,
the display will show as many characters as possible starting at the
beginning of the partition name. We recommend that the partition
name be kept to a maximum of 7 characters to ensure the "H"
which indicates the home partition may be seen.
• "Exit Error" and "Auto Arm Alert, Please Leave Now" messages are
not displayed by the TouchCenter.
• When the system has 6150Vs or 6160Vs, and 6271Vs attached, the
Additional Console setting in the 6150Vs (displayed as A on the
6150V) must be set to 1 and the Additional Console setting in the
6160Vs must be set to Yes.
Commercial System Notes
• If the Aux Relay function is set for alarm silenced by User Code + #
+ 67, this command may only be entered in the console emulation
mode.
• Do not use the common lobby logic function.
• If fields 2*22 (Display Fire Alarms of other Partitions), 2*23
(Display Burg & Panic of other Partitions), or 2*24 (Display
Troubles of other Partitions) are enabled, the zones that created the
conditions cannot be viewed. You must go to that zone's home
partition to view.
• If field 1*11 (Zone Bypass After Disarm) is enabled, you must use
the TouchCenter's Console Emulation Mode and the commands
"Code" + "64" (unbypass all) or "Code" + "6" + "Zone Number"
(unbypass zone) to remove zone bypasses.
• The First to Alarm Display Lock feature (field 1*10) is not
supported by the TouchCenter.
• RF Low Battery messages are not supported by the TouchCenter
except in the Show Zones screen where a Battery Icon will be
displayed for the zone with the low battery.
• On multi-partition systems when the user has access to multiple
partitions and arms the system, the TouchCenter will always ask
the arm multiple partitions question regardless of the "Arm Multi-
Partitions" setting.
Residential System Notes
• If the Clean Me option is set, when the maintenance signal is
received you will get a "Fire Maintenance" message and the Display