Honeywell ADEMCO 6271 Series Installation And Setup Manual page 10

TouchCenter Installation and Setup Guide
2. Connect ground to the TouchCenter using step a or b below.
a. If powering the keypad from the control panel, connect the
AUX – terminal of the control panel to the – terminal block
position (GND terminal of the TouchCenter (black wire)).
b. If powering the keypad from a supplementary power supply,
connect the AUX – terminal of the control panel to the (–)
terminal of the supplementary power supply (black wire).
Then, connect the (–) terminal of the supplementary power
supply to the – terminal block position (GND terminal of the
TouchCenter (black wire)).
3. Connect Data Out terminal of the control panel to the Y terminal
block position (Data In terminal of the TouchCenter (yellow
wire)).
4. Connect the Data In terminal of the control panel to the G
terminal block position (Data Out terminal of the TouchCenter
(green wire)).
5. Mount the TouchCenter onto the mounting plate as shown in
Figure 3.
TOUCHCENTER
Figure 3. Mounting the TouchCenter
2–4
WALL
MOUNTING
PLATE
TYPICAL
4
PLACES
6271CV-007-V0