Makita HR262D Technical Information page 9

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3]-3. Change lever
DISASSEMBLING
Fig. 19
While pushing Lock button into Change lever,
turn Change lever a little over Drill mode position
to lock it in place.
Drill mode
ASSEMBLING
Fig. 20
Change plate can be seen through Change lever insertion hole of Gear housing complete.
While hooking the thin pin of Change lever to Change plate from Hammer mode side,
turn Change lever to Drill mode side.
Note: Change lever is incompletely fit to Gear housing complete in the above step.
Change plate
Drill mode
Fig. 21
While pushing Lock button into Change lever, fit Change lever
completely to Gear housing complete.
Note: Be sure to check Change lever works properly
after assembling.
Lock button
Change lever
Lock button
Hammer mode
thin pin of
Change lever
(thick pin of
Change lever)
Change lever
Insert slotted screwdriver between Change lever and
Gear housing complete, then lever up Change lever.
Viewed from the upper side
Drill mode
P 9/22
slotted screwdriver