Makita HR262D Technical Information page 15

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3]-7. Impact bolt in Tool holder complete for BHR262, HR262D)/
Tool holder guide complete for BHR262T, HR262TD
DISASSEMBLING
(1) When Striker is left in Tool holder (guide) complete, push Striker out of Tool holder (guide) complete
by inserting 1R281 from the top end then by striking 1R281 with plastic hammer.
(2) Remove Tool holder (guide) section as instructed in [3]-5.
(3) Remove Ring spring 28 from Tool holder (guide) complete and disassemble Impact bolt section. (Figs. 38 to 41)
Fig. 38
Note:
If the end gap of Ring spring 28 is in the hole of
Tool holder (guide) complete, slide it with a slotted
screwdriver until it is completely hidden.
end gap of Ring spring 28
Slotted
screwdriver
Fig. 39
Insert 1R249 into Tool holder (guide) complete from
Inner housing complete side, then put it on arbor press table
as drawn on the right.
Press down Tool holder (guide) complete using arbor press.
Using slotted screwdriver and plastic hammer,
tap Ring spring 28 through the two holes located on the
opposite side to each other alternately to push the ring down
out of the groove inside Tool holder (guide) complete.
Tool holder (guide) complete
[Inner housing complete side]
Fig. 40
Ring spring 28 can be pulled off
from Tool holder (guide) complete
when completely removed from
the groove.
Note:
Be sure to replace Ring spring 28
when assembling Tool holder (guide)
section.
Tool holder (guide) complete
Ring spring 28
Ring spring 28
[Cap 35 side]
Ring spring 28
Fig. 41
Disassemble Impact bolt
section by striking Tool
holder (guide) complete
against workbench.
P 15/22
Tool holder (guide) complete
[Cap 35 side]
[Inner housing
complete side]
1R249
Tool holder (guide) complete
Impact bolt section
Sleeve 9
Impact bolt
Ring 10
Cushion ring 13
O ring case with
O ring 9 fit inside