Makita HR262D Technical Information page 5

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -1. Bit holder section for BHR262, HR262D
Holder section for Drill chuck of BHR262T, HR262TD
DISASSEMBLING for BHR262, HR262D
Fig. 4
Remove Cap 35 with slotted screw-
driver, then remove Ring spring 19
using 1R003 with 1R212.
1R003
1R212
Ring 21
Chuck
cover
ASSEMBLING for BHR262, HR262D
Take the disassembling step in reverse.
Note: Be sure to place the flat portion of Ring spring 19 on Steel ball 7.0. (Fig. 4)
DISASSEMBLING for BHR262T, HR262TD
Fig. 5
Separate Tool holder set
from Tool holder guide
complete.
Tool holder set
Tool holder guide
Stopper, Guide washer,
Conical compression
spring 21-29, Flat washer
21 can be disassembled
as drawn above.
Stopper
Guide washer
Conical
compression
spring 21-29
Flat washer 21
Tool holder
Separate Chuck cover.
Then remove Steel ball 7.0
while pressing down Ring 21.
Chuck cover
Cap 35
Ring spring 19
flat portion
Remove Cap 35 with slotted screw-
driver, then remove Ring spring 19
using 1R003 with 1R212.
Cap 35
Ring spring 19
Remove Ring spring 21
with 1R004 from Tool
holder guide side. Flat
washer 24, Leaf spring
and Steel ball 5 can be
disassembled.
Ring spring 21
Flat washer 24
Leaf spring
Steel ball 5
Steel ball 7.0
Ring 21
1R003
1R212
Remove Tool holder
together with Change
ring from Change cover.
And separate Change
ring from Tool holder.
Tool holder
Torsion spring 31
Change ring
Change cover
Bit holder section can be
disassembled as drawn above.
Ring 21
Guide washer
Conical
compression
spring 21-29
Separate Chuck cover. Then
remove Steel ball 7.0 while
pressing down Stopper.
Chuck cover
Stopper
Steel ball 7.0
After removing Torsion
spring 31, Steel ball 6
can be separated from
Tool holder.
Torsion spring 31
Steel ball 6 (2 pcs.)
P 5/22