Connecting The Power Cable - Honeywell Thor VM3 Quick Start Manual

Connecting the Power Cable

The following power option is for 12-48VDC vehicles (10-60VDC
direct connection).
CAUTION - For installation by trained service personnel only.
Fuse Requirements
WARNING - For proper and safe installation, the input power
cable must be connected to a fused circuit on the vehicle. If
the supply connection is made directly to the battery, the fuse
should be installed in the positive lead within 5 inches of the
battery's positive (+) terminal. Use VM3055FUSE (or equiva-
lent) to install the fuse as shown below:
• For 12VDC input, use the 10A fuse from the kit or a slow
blow fuse that has a DC voltage rating greater than 12VDC.
• For 24VDC input, use the 6A fuse from the kit or a slow
blow fuse that has a DC voltage rating greater than 24VDC.
• For 36VDC input, use the 4A fuse from the kit or a slow
blow fuse that has a DC voltage rating greater than 36VDC.
• For 48VDC input, use the 3A fuse from the kit or a slow
blow fuse that has a DC voltage rating greater than 48VDC.
Note: For North America, a UL Listed fuse is to be used
• Route the power cable away from the outside of the forklift.
• Choose a mounting location so that the power cable does not
extend outside the vehicle and that provides sufficient clearance
so that the power cable (especially the dock connector end) is not
pressed against part of the vehicle.
• Regularly inspect power cable for damage, especially in low
temperature environments.