Power Cable Installation - Honeywell Thor VM3 Quick Start Manual

Hide thumbs Also See for Thor VM3:

Table of Contents

Connect the green wire to vehicle ground:

For battery powered vehicles:

The green wire must be connected to the vehicle chassis

ground.

For internal combustion engine powered vehicles:

The green wire is connected to the vehicle chassis

ground, which can also be battery negative.

Wire Color

Red

Red/White

Black

Black/White

Green

Blue

Power Cable Installation

1. The Thor VM3 must not be mounted in the Smart Dock.

The power switch on the dock must be turned Off. The

power cable must be UNPLUGGED from the dock.

2. Install the VM3 fuse kit (or equivalent slow blow fuse) within

5" (12.7 cm) of the vehicle battery (if using unswitched

power). Refer to the installation instructions included with

the fuse kit or Fuse Requirements earlier in this document.

3. The cable is rated for a maximum temperature of 221°F

(105°C). The cable should be protected from surfaces that

Connection

DC + (10-60 VDC)

DC -

Ground

Ignition Input (optional)

Refer to the Thor VM3 User's Guide, avail-

able at www.honeywellaidc.com, for further

information about ignition control.

Table of Contents