Rear Panel - NETGEAR R7000 User Manual

Table 1. LED and button descriptions (continued)
LED Description
Ethernet ports The LED color indicates the speed: white for Gigabit Ethernet connections and amber for 100
1-4 Mbps or 10 Mbps Ethernet connections.
•
•
•
WiFi On/Off Pressing this button for two seconds turns the 2.4 GHz and 5 GHz WiFi radios on and off.
button with LED
If this LED is lit, the WiFi radios are on. If this LED is off, the WiFi radios are turned off and you
cannot use WiFi to connect to the router.
WPS button with This button lets you use WPS to join the WiFi network without typing the WiFi password. The
LED WPS LED blinks white during this process and then lights solid white.
You can disable LED blinking or turn off all LEDs except the Power LED. For information
about how to do this, see

Rear Panel

The rear panel has the connections and buttons shown in the following figure.
Reset
button
Figure 3. Router rear panel
Pressing the Reset button restores the factory settings. See
Nighthawk AC1900 Smart WiFi Router
Solid. A powered-on device is connected to the Ethernet port.
Blinking. The port is sending or receiving traffic.
Off. No device is connected to this Ethernet port.
Disable LED Blinking or Turn off LEDs
Ethernet Internet
port
LAN ports 1–4
Hardware Setup
on page 118.
USB 2.0 Power
port On/Off connector
Factory Settings
11
Power
on page 192.