NETGEAR R7000 User Manual page 39

The page adjusts:
6. Enter the settings that your service provider gave you.
If your service provider gave you only one user name and password, the service provider
most likely supports dual stack PPPoE (a single ppp session). If the service provider gave
you two user names and passwords for IPv4 and IPv6, then the router must use different
PPP session.
• To use separate PPP sessions (the default setting), leave the Use the same Login
information as IPv4 PPPoE check box cleared and complete the PPP Login and
Password fields.
• To use a single PPP session to establish the IPv4 and IPv6 Internet connection,
select the Use the same Login information as IPv4 PPPoE check box.
The page adjusts and the router automatically detects the information in Router's
IPv6 Address on WAN field. Go to
Note: If you do not see the Use the same Login information as IPv4
PPPoE check box, make sure that PPPoE is selected from the
Internet Service Provider list on the Internet Setup page. For more
information, see
page 25.
The Router's IPv6 Address on WAN field shows the IPv6 address that is acquired for
the router's WAN (or Internet) interface. The number after the slash (/) is the length of the
prefix, which is also indicated by the underline (_) under the IPv6 address. If no address
is acquired, the field displays Not Available.
The Router's IPv6 Address on LAN field shows the IPv6 address that is acquired for
the router's LAN interface. The number after the slash (/) is the length of the prefix, which
is also indicated by the underline (_) under the IPv6 address. If no address is acquired,
the field displays Not Available.
7. In the Login field, enter the login information for the ISP connection.
Nighthawk AC1900 Smart WiFi Router
Step 10.
Specify an Internet Connection That Uses a Login
Specify Your Internet Settings
39
on