NETGEAR R7000 User Manual page 17

When your Internet service starts, your Internet service provider (ISP) typically gives you all
the information needed to connect to the Internet. For DSL service, you might need the
following information to set up your router:
• The ISP configuration information for your DSL account
• ISP login name and password
• Fixed or static IP address settings (special deployment by ISP; this setting is rare)
If you cannot locate this information, ask your ISP to provide it. When your Internet
connection is working, you no longer need to launch the ISP login program on your computer
to access the Internet. When you start an Internet application, your router automatically logs
you in.
NETGEAR genie runs on any device with a web browser. Installation and basic setup takes
about 15 minutes to complete.
To use NETGEAR genie to set up your router:

1. Turn the router on by pressing the On/Off button.
2. Make sure that your computer or wireless device is connected to the router with an Ethernet
cable (wired) or wirelessly with the preset security settings listed on the label.
Note: If you want to change the router's WiFi setting, use a wired connection
to avoid being disconnected when the new WiFi settings take effect.
3. Launch a web browser.
The page that displays depends on whether you have accessed the router before or if
NETGEAR genie detects that the router is connected to another router or gateway:
• The first time that you are setting up the Internet connection for your router, the
browser goes to http://www.routerlogin.net, and the NETGEAR genie page
displays.
Nighthawk AC1900 Smart WiFi Router
Connect to the Network and Access the Router
17