Information Submenu; Information Pages; Expander Board Information; Expander Board Information Menus - Honeywell NX series User Manual

7
76(86)
7.3.6.7

Information submenu

In the Information submenu (S6.7) frequency converter-related hardware and software information
as well as operation-related information, can be found.
Enter the Info menu by pressing the
the information pages with the
Page
6.7.1 Nominal power of the unit (constant torque)
6.7.2 Nominal voltage of the unit
6.7.3 Control board software version
6.7.4 Application interface version of the software
6.7.5 Expander board statuses and program versions
6.7.6 Application-related software information
6.7.7 Debug menu (for advanced users)
Table 7-6. Information pages
Expander board information (S6.7.5)
Information about the basic and option boards connected to the control board can be found in the
Expanders submenu (see Chapter 6.2).
You can check the status of each slot by entering the board submenu with the
button and using the
the right arrow menu button
the program version of the respective board when either one of the
If no board is connected to the slot the text 'no board' will be shown. If a board is connected to a
slot but the connection is somehow lost the text 'no conn.' is displayed. See Chapter 6.2 and
Figure 6-12 and 6-11 for more information.
For more information on the expander board-related parameters, see Chapter 7.3.7.
I/Oterm
Expanders
"
E1
Figure 7-22. Expander board information menus
right arrow menu
Browser
Content
Browser buttons to choose the board whose status you wish to check. Push
again to display the status of the board. The keypad will also display
B:NXOPTA2
READY
A:NXOPTA1A
E7
Control keypad
button. The user can now browse through
buttons.
R EADY
I/Oterm
E2
E1 "
READY
I/Oterm
E2
"
E1
right arrow menu
Browser buttons is pushed.
I/Oterm
Program version
10001.0
I/O term
State
Run