System Settings; Selection Of Language; Password Setting - Honeywell NX series User Manual

7
68(86)
System Menu
Language
English
Figure 7-10. Selection of language
7.3.6.3

System settings

In the System settings submenu (S6.3) under the System menu it is possible to further customise
the frequency converter operator interface. The functions available in this menu are Password,
Parameter lock, Internal brake resistor connection, Fan control, HMI acknowledge timeout
and HMI retry.
Password (S6.3.1)
The application selection can be protected against unauthorised changes with the Password
function (S6.3.1).
By default, the password function is not in use. To activate the function, enter the edit mode by
pushing the right arrow menu
be set with the Browser
Note The password can be set by digits. In the edit mode, push the
again and another zero appears on the display. First set the units. Push the
button and set the tens etc. Finally, confirm the password setting with the
wait until the Timeout time (P6.4.3) (see page 72) has expired before the password function is
activated.
If the applications or the password itself are changed
password. The password will be entered with the
Figure 7-11. Password setting
READY
I/O term
Password
Not in use
Note! Store the password in a secure location! No changes can be made unless a valid password
is entered!
Control keypad
READY
I/O term
"
S1 S11
READY
I/Oterm
button. A blinking zero appears in the display and a password can
buttons. The password can be any number between 1 and 65535.
I/Oterm
Password
I/Oterm
Language
English
I/Oterm
Language
enter
Suomi
the system will request
Browser buttons.
READY
enter
OR:
0
READY
READY
right arrow menu button
left arrow menu
Enter button. After this,
READY
I/O term
Password
00
once
the current
enter