Parameter Comparison - Honeywell NX series User Manual

If the user wants the parameters of the new application to be automatically uploaded to the
keypad this will have to be done for the parameters of the new application once on page 6.5.1 as
instructed. Otherwise the panel will always ask for the permission to upload the parameters.
Note: Parameters saved in the parameter settings on page S6.5.3 will be deleted when
applications are changed If transfer of the parameters from one application to another is required,
they must be uploaded first to the keypad.
7.3.6.6

Parameter comparison

In the Parameter comparison submenu (S6.6), the actual parameter values to the values of
thecustomised parameter sets and those loaded to the control keypad can be compared.
The comparison is performed by pushing the
comparison submenu. The actual parameter values are first compared to those of the customised
parameter Set1. If no differences are detected a '0' is displayed on the lowermost line. But if any
of the parameter values differ from those of the Set1 the number of the deviations is displayed
together with symbol P (e.g. P1#P5 = five deviating values). By pressing the
button once again it is possible to enter the pages where both the actual value and the value it
was compared to can be seen. In this display, the value on the
the default value and the one on the
possible to also edit the actual value with the
by pushing the right arrow menu button
RE ADY
I/Oterm
ParamComparison
"
C1 C3
Figure 7-21. Parameter comparison
Control keypad
right arrow menu button
value line (lowermost) is the edited value. Furthermore, it is
Browser buttons
once again.
RE ADY
I/Oter m
Set1
0
OR
READY
I/Oterm
Set1
"
P1 P6
READY
I/Oterm
P2.1.2= 50.0
20.0 Hz
when in the Parameter
right arrow menu
Description line (in the middle) is
in the edit mode that you can reach
READY
I/Oterm
P2.1.2= 50.0
20.0 Hz
EDIT VALUE
CONFIRM CHANGE
enter
7
75(86)