Keypad Settings - Honeywell NX series User Manual

Example:
Transfer delay between the frequency converter and the PC = 600 ms
The value of par. 6.3.6 is set to 1200 ms (2 x 600, sending delay + receiving
delay)
The corresponding setting shall be entered to the
NCDrive.ini – file:
It must also be considered that intervals that are shorter than the AckTimeOut-time cannot be
used in NCDrive monitoring.
Enter the edit mode by pushing the
the acknowledgement time. Accept the change with the
with the left arrow menu button
I/Oterm
HMI ACK timeout
200ms
Figure 7-15. HMI acknowledge timeout
Number of retries to receive HMI acknowledgement (P6.3.7)
With this parameter it is possible to set the number of times the drive will try to receive
acknowledgement if this does not happen within the acknowledgement time (P6.3.6) or if the
received acknowledgement is faulty.
Enter the edit mode by pushing the
blink. Use the Browser buttons
button or return to the previous level with the
See Figure 7-15 for the procedure of changing the value.
7.3.6.4

Keypad settings

Further customisation of the freqency converter operator interface can be undertaken in the
Keypad settings submenu under the System menu.
Locate the Keypad settings submenu (S6.4). Under the submenu, there are four pages (P#)
associated with the keypad operation:
Control keypad
Retries = 5
AckTimeOut = 1200
TimeOut = 6000
right arrow menu
.
READY
I/O term
HMI ACK timeout
200ms
right arrow menu
to change the amount of retries. Accept the change with the
left arrow menu button
button. Use the Browser buttons
Enter button or return to the previous level
READY
enter
button. The present value shown starts to
7
71(86)
Misc -part of the
to change
Enter