Advertisement
R
epair
[3] DISASSEMBLY/ASSEMBLY
[3]-1. Motor Section (cont.)
DISASSEMBLING
(6) After removing Endbell and Field, Motor section is disassembled as drawn in Fig. 7.
Fig. 7
1. Disassemble Endbell and Field from Base by
unscrewing two M5x60 Pan head screws.
Endbell
Field
3. Gripping Armature by hand firmly, remove M8 Hex nut by
turning it counterclockwise with Impact driver.
And then, remove Flat washer 10 and the lower-side Fan 125.
(lower-side) Fan 125
5. Cover Armature with cloth and receive them on 1R258.
Applying a slotted screwdriver to a notch on Base and strike
screwdriver carefully with hammer to remove Return vane.
Slotted
notch on Base
screwdriver
7. Remove Armature from Base.
M5x60 Pan
Slotted screwdriver
head screw (2pcs.)
Flat washer 10
M8 Hex nut
Return vane
Armature
2. Remove Fan cover by pushing with Slotted screwdriver.
Lower-side Fan 125 comes into sight.
Fan cover
4. Tighten M8 Hex nut provisionally
so that Armature does not fall off.
6. Return vane is removed. And then, Spacer,
upper-side Fan 125 and Flange are removed.
(upper-side) Fan 125
Base
Flange
Base
P 5/ 23
(lower-side) Fan 125
M8 Hex nut
Return vane
Spacer
Advertisement
