Table of Contents
Advertisement
■ Edit Mode
For the parameters you set or change in the POS Programming module, there are two edit modes,
programming mode and maintenance mode.
You should first specify an edit mode before you start programming. When you select Edit Mode, the
edit mode selection window will open.
Programming mode
The parameters you will change directly affects the data base of your Back Office.
Maintenance mode
The parameters you will change are saved in the maintenance file. The data will be downloaded to the
data base by either executing a download operation manually in the Maintenance Data List module or
setting a date and time for downloading.
NOTE
You can control and download the maintenance data on the Maintenance Data List in Supervisor of
System Setting module.
45
Advertisement
Table of Contents
