Show Spanningtree Summary; Config Spanningtree Adminmode - NETGEAR 7200 Series User Manual

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
• Show commands display spanning tree settings, statistics, and other information.
• Config commands configure features and options of the switch. For every config command
there is a show command that displays the config setting.
This section is organized by configuration type:
• System information and statistics commands
• Bridge and CIST commands
• MSTI commands
• Modified commands
• Obsolete commands

show spanningtree summary

This command displays spanning tree settings and parameters for the switch.
Format
Spanning Tree Adminmode
Spanning Tree Version
Configuration Name
Configuration Revision
Level
Configuration Digest Key
Configuration Format
Selector
MST Instances

config spanningtree adminmode

This command sets the spanningtree operational mode. While disabled, the spanningtree
configuration is retained and can be changed, but it is not activated.
Default
Format
7-46
show spanningtree summary
Enabled or disabled.
Version of 802.1 currently supported (IEEE 802.1s, IEEE 802.1w, or IEEE
802.1d) based upon the Force Protocol Version parameter.
TConfigured name.
Configured value.
Calculated value.
Configured value.
List of all multiple spanning tree instances configured on the switch.
disable
config spaningtree adminmode <enable/disable>
202-10010-01
Switching Commands