User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
config syslocation
This command sets the physical location of the switch. The range for the name is from 1 to 31
alphanumeric characters.
Default
Format
config syscontact
This command sets the organization responsible for the network. The range for the name is from 1
to 31 alphanumeric characters.
Default
Format
show arp switch
This command displays connectivity between the switch and other devices. The Address
Resolution Protocol (ARP) cache identifies the MAC addresses of the IP stations communicating
with the switch.
Format
MAC Address
IP Address
Slot.Port
show forwardingdb table
This command displays the forwarding database entries. If the command is entered with no
parameter, the entire table is displayed. This is the same as entering the optional
Alternatively, the administrator can enter a MAC Address to display the table entry for the
requested MAC address and all entries following the requested MAC address.
Format
Mac Address
Switching Commands
Blank
config syslocation <location>
Blank
config syscontact <contact>
show arp switch
A unicast MAC address for which the switch has forwarding and/or filtering
information. The format is 6 two-digit hexadecimal numbers that are separated
by colons, for example: 01:23:45:67:89:AB
The IP address assigned to each interface.
This parameter denotes a valid slot number and a valid port number.
show forwardingdb table [macaddr/all]
A unicast MAC address for which the switch has forwarding and or filtering
information. The format is 6 or 8 two-digit hexadecimal numbers that are
separated by colons, for example, 01:23:45:67:89:AB. In an IVL system the
MAC address will be displayed as 8 bytes. In an SVL system, the MAC address
will be displayed as 6 bytes.
202-10010-01
parameter.
all
7-3