User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
config protocol protocol add
This command adds the <protocol> to the protocol-based VLAN identified by <groupid>. A group
may have more than one protocol associated with it. Each interface and protocol combination can
only be associated with one group. If adding a protocol to a group causes any conflicts with
interfaces currently associated with the group, this command will fail and the protocol will not be
added to the group. The possible values for protocol are
Default
Format
config protocol protocol remove
This command removes the
by this
. The possible values for protocol are
<groupid>
Default
Format
config protocol vlan add
This command attaches a <vlan> to the protocol-based VLAN identified by <groupid>. A group
may only be associated with one VLAN at a time, however the VLAN association can be changed.
Default
Format
config protocol vlan remove
This command removes the
this
.
<groupid>
Default
Format
7-34
none
config protocol protocol add <groupid> <protocol>
from this protocol-based VLAN group that is identified
<protocol>
none
config protocol protocol remove <groupid> <protocol>
none
config protocol vlan add <groupid> <vlan>
from this protocol-based VLAN group that is identified by
<vlan>
none
config protocol vlan remove <groupid> <vlan>
202-10010-01
and
.
ip, arp,
ipx
and
.
ip, arp,
ipx
Switching Commands