Config Snmptrap Ipaddr; Config Snmptrap Mode; Show Trapflags - NETGEAR 7200 Series User Manual

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software

config snmptrap ipaddr

This command assigns an IP address to a specified community name. The maximum length of
name is 16 case-sensitive alphanumeric characters.
Note: IP addresses in the SNMP trap receiver table must be unique. If you make multiple entries
using the same IP address, the first entry is retained and processed. All duplicate entries are
ignored.
Format

config snmptrap mode

This command activates or deactivates an SNMP trap. Enabled trap receivers are active (able to
receive traps). Disabled trap receivers are inactive (not able to receive traps).
Format

show trapflags

This command displays trap conditions. Configure which traps the switch should generate by
enabling or disabling the trap condition. If a trap condition is enabled and the condition is detected,
the switch's SNMP agent sends the trap to all enabled trap receivers. The switch does not have to
be reset to implement the changes. Cold and warm start traps are always generated and cannot be
disabled.
Format
Authentication Flag
Link Up/Down Flag
Multiple Users Flag
Spanning Tree Flag
Broadcast Storm Flag
7-20
config snmptrap ipaddr <ipaddrold> <name> <ipaddrnew>
config snmptrap mode <enable|disable> <name> <ipaddr>
show trapflags
May be enabled or disabled by selecting the corresponding line on the pull-
down entry field. The factory default is enabled. Indicates whether
authentication failure traps will be sent.
May be enabled or disabled by selecting the corresponding line on the pull-
down entry field. The factory default is enabled. Indicates whether link status
traps will be sent. Multiple Users Flag.
May be enabled or disabled by selecting the corresponding line on the pull-
down entry field. The factory default is enabled. Indicates whether a trap will be
sent when the same user ID is logged into the switch more than once at the same
time (either via telnet or serial port).
May be enabled or disabled by selecting the corresponding line on the pull-
down entry field. The factory default is enabled. Indicates whether spanning tree
traps will be sent.
May be enabled or disabled by selecting the corresponding line on the pull-
down entry field. The factory default is enabled. Indicates whether broadcast
storm traps will be sent.
202-10010-01
Switching Commands