Config Igmpsnooping Adminmode; Config Igmpsnooping Groupmembershipinterval; Config Igmpsnooping Maxresponse; Config Igmpsnooping Mcrtrexpiretime - NETGEAR 7200 Series User Manual

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software

config igmpsnooping adminmode

This command enables or disables IGMP Snooping on the system. The default value is disable.
Format

config igmpsnooping groupmembershipinterval

This command sets the IGMP Group Membership Interval time on the system. The Group
Membership Interval time is the amount of time in seconds that a switch will wait for a report from
a particular group on a particular interface before deleting the interface from the entry. This value
must be greater than the IGMP Maximum Response time value. The range is 1 to 3600 seconds.
Default
Format

config igmpsnooping maxresponse

This command sets the IGMP Maximum Response time on the system. The Maximum Response
time is the amount of time in seconds that a switch will wait after sending a query on an interface
because it did not receive a report for a particular group in that interface. This value must be less
than the IGMP Query Interval time value. The range is 1 to 3600 seconds.
Default
Format

config igmpsnooping mcrtrexpiretime

This command sets the Multicast Router Present Expiration time on the system. This is the amount
of time in seconds that a switch will wait for a query to be received on an interface before the
interface is removed from the list of interfaces with multicast routers attached. The range is 0 to
3600 seconds. A value of 0 indicates an infinite timeout, i.e. no expiration.
Default
Format
Switching Commands
config igmpsnooping adminmode <enable/disable>
260 seconds
config igmpsnooping groupmembershipinterval <1-3600>
10 seconds
config igmpsnooping maxresponse <1-3600>
0
config igmpsnooping mcrtrexpiretime <0-3600>
202-10010-01
7-39