How To Regulate The Buzzer Volume; How To Program The System; How To Activate / Deactivate A Function - Cobra BRIDGE 4100 Fitting Instructions Manual

HOW TO REGULATE THE BUZZER VOLUME

To adjust the buzzer volume it is necessary to access the system's "Programming" function
(see: how to programme the system). To increase the buzzer volume, press the A key on the
radiocontrol device, or give the button on the LED panel several short presses.
To reduce the buzzer volume, press the B key on the radiocontrol device, or give the button
on the LED panel several long presses.

HOW TO PROGRAM THE SYSTEM

To enter the programming section, the system must be disconnected (is the "Anti-robbery"
function is enabled, enter the first two digits of the Pin code via the push - button located on
the LED panel), the door and the boot must be open and the dashboard turned on (+ 15
present). Keep the "A" key on the radiocontrol device pressed down or type out the Pin Code
in full. If all the required conditions have been met, the LED on the emergency panel will
light up with a steady light and after about 3 s the system will respond by flashing the
direction arrows to inform you that you have accessed the programming function. At this
point it is possible to enter "radio control / Driver Card / Jack key self - learning" mode by
entering the whole Pin Code, or to enter Page 1 "buzzer volume adjustment" by switching
the dashboard panel on and off.
To proceed onwards to the next page, turn the ignition key to OFF position then back to ON.
The system always confirms that you have moved from one table to another by flashing the
direction indicators: the number of flashes will be the same as the number of the table in
which you are positioned at the time. This signal sequence will be repeated approximately
every 10 s as a reminder of the number of the page currently accessed.

HOW TO ACTIVATE / DEACTIVATE A FUNCTION

After accessing one of the tables, press radiocontrol button "A" or shortly push the control
panel button and position yourself on the line number corresponding to the function you
want to enable / disable. Fast flashing indicates that the function is deactivated, whilst slow
flashing indicates that it is active. The number of flashes will be the same as that of the line
in the functions table that you have selected. To enable / disable a function, press radiocontrol
button "B" or keep pushed the control panel button unto the LED flash frequency change.
Several functions on the same page can be enabled at the same time. Enabling one
function does not automatically disable the others. When you have finished, close the
vehicle's bonnet and the system will signal by flashing the direction arrows for 3 s that you
have exited the programming procedure. Beside the tables, in which you will find the
programmable functions subdivided into buzzer, basic and advanced, the programming
procedure is shown in diagram form; this will be useful as a quick reminder when carrying out
the various phases.
23
Fitting instructions - BRIDGE 4100
06DE2143E.pmd 23 07/02/2008, 15.15