Battery Powered Wireless Devices; Radiator Controller (Hr92) - Honeywell Evohome Installation Manual

evohome Installation Guide

Battery Powered Wireless Devices

Battery powered devices need to be put into
test mode to send and receive a test signal:

Radiator Controller (HR92)

Press the button, the zone name is displayed
1
Press and hold the
2
seconds, the display should say BIND
Turn the dial to display RF CHECK
3
Press the button, the display
4
should flash CHECKING
Press the button again, the display should
5
flash SIGNAL and will display a signal strength
bar and a rating from 1 (poor) to 5 (excellent) – 0
means the Radiator Controller has not received
a test signal from the evohome Controller.
To exit test mode turn the dial to exit and press the
6
button. It will also exit automatically after 10 minutes.
1 2
PRESS
AND HOLD
4 SEC
button again for 5
3 4
"RF CHECK"
31