Underfloor Heating Controller (Hce80 Or Hcc80) - Honeywell Evohome Installation Manual

24
Underfloor Heating Controller (HCE80 or HCC80)
evohome
Controller
If you are NOT
following GUIDED
CONFIGURATION
follow these steps
on your evohome
Controller display once
the underfloor heating
controller and sensors
have been fitted:
1. On the evohome
Controller press and
hold "Settings" for
3 seconds
2. Press the green tick
3. Press ADD ZONE
4. Type a name for the
new zone and press
the green tick
5. Press UNDERFLOOR
HEATING
6. You need to install
a sensor (HCW82,
HCF82, DTS92) in
each zone controlled
by the underfloor
heating controller
and bind it to the
evohome Controller.
You need to repeat this
process for every zone
that uses underfloor
heating.
!
Make sure the zone
you're adding on the
evohome Controller
corresponds to the
correct underfloor
heating zone.
Step 3: Power up and bind devices
Power up and bind an Underfloor Heating
Controller (HCE80 or HCC80)
If you want to control the zone temperature with your evohome
Controller (the evohome Controller needs to be located in that
zone) press YES, otherwise press NO and bind a sensor – either
Digital Room Thermostat (DTS92), Single Zone Thermostat
(Y87RF), or Room Temperature Sensor (HCW82/HCF82)
To bind the Digital Room Thermostat (DTS92)
Press and hold the power button
1
seconds to put the unit into standby
Press the up and down arrows together for
2
three seconds – it should say INst
Press the down arrow – it should say COnt
3
Press the up arrow three times – it should say CLr
4
Press the once to clear any previous binding data
5
Press the up arrow – it should say COnt
6
Press the once to send the binding
7
signal to the evohome Controller
You should receive a SUCCESS message on the
8
evohome Controller (if not go back and re-bind)
To bind the Single Zone Thermostat (Y87RF)
Press and hold on the left touch zone (just below
1
and to the left of the display) for approximately
10 seconds until a flashing 'Bo' is displayed
Turn the dial clockwise until a flashing 'Co' is displayed
2
Press the left touch zone once to send the
3
binding signal to the evohome Controller
You should receive a SUCCESS message on the
4
evohome Controller (if not go back and re-bind)
for 2