Parameters And Control Features; Configuring A Zone With Multiple Rooms; To Create A Multiple Room Zone Either - Honeywell Evohome Installation Manual

38

Parameters and control features

Configuring a zone with multiple rooms

!
A multiple room zone
does not support
separate remote
temperature sensors
(such as DTS92).
Room temperature
sensing is done by the
radiator controllers.
Configuration and modification
Once you've completed these steps you're ready to
start using evo. The user guide gives you instructions for
personalising the settings on the evohome Controller.
You can also make parameter adjustments on your evohome
Controller to match the exact requirements of the heating
system. These can be found in the Installer Menu.
On the evohome Controller press and
1
hold 'Settings' for 3 seconds
Press the green tick
2
Press SYETEM PARAMETERS and choose
3
the parameter you want to adjust:
– Internal Sensor Offset
– Cycle Rate
– Minimum On Time
– Fail Safe
– Hot Water Parameters
For more details on parameters visit
www.evohome.honeywell.com
evohome allows you to create a zone with multiple rooms
(i.e. Bedroom's) that are controlled together as one group.
It does this by letting all the radiator controllers bound to
that zone to independently measure room temperature and
control a radiator. This means you can locate the radiator
controllers in separate rooms without them all being controlled
by one temperature sensor like a single room zone does.

To create a multiple room zone either:

• Add a new zone and bind the radiator controllers
for all the rooms. Go to the parameters
menu and select multiple room zone.
or
• Go to Zone Configuration and edit an existing zone's
parameters. Any bound radiator controllers already
bound to that zone will now work independently