Draytek Vigor2860 series User Manual page 787

send
stus
tag
user
wms
E x a m p l
E x a m p
> wan lte band
Access technology : LTE
Access band information : E-UTRA Op Band 3
Interfere with 2.4G WLAN : NO
Active channel: 1725
>wan lte stus
Status: Operational. (Online)
Access Tech: LTE
Band: E-UTRA Op Band 3
ISP: Chunghwa
MCC: 466, MNC: 92, LAC: 65534, Cell ID: 81023501
Max Channel TX Rate: 50000000 bps
Max Channel RX Rate: 100000000 bps
IMEI: 356318040749422
IMSI: 466924200859808
RSSI: -61 dBm
Unread SMS: 4
SMSC address: +886932400821
SMS service status : Ready
Number of SMS sent : 0
T e l n e t C o m m
T e l n e t C o m m
This command allows you to configure WAN connection detection. When Ping Detection is
enabled (for Static IP or DHCP or PPPoE mode), Router pings specified IP addresses to detect
the WAN connection.
S y n t a x
S y n t a x
wan detect [wan1/wan2/wan3/wan4][on/off/always_on]
wan detect [wan1/wan2/wan3/wan4] target [ip addr]
wan detect [wan1/wan2/wan3/wan4] target2[ip addr]
wan detect [wan1/wan2/wan3/wan4] target_gw [1/0]
wan detect [wan1/wan2/wan3/wan4] ttl [value]
wan detect [wan1/wan2/wan3/wan4] interval [interval]
wan detect [wan1/wan2/wan3/wan4] retry [retry]
wan detect status
Vigor2860 Series User's Guide
-x <number>: Set the first phone number in Access Control List.
-y <number>: Set the second phone number in Access Control List.
-z <number>: Set the third phone number in Access Control List.
Send an SMS message to the specified phone number through the
LTE SIM card.
Display status of LTE connection.
Set an SMS in the LTE SIM card as read state by specifying the index
number. Use "all" to set all SMS as read state.
Set the UserName of LTE WAN.
This command is for RD debug only. We use it to test new USB
modems. Please don't use it without our advice.
e
l e
a n d : w a n d e t e c t
a n d : w a n d e t e c t
773