Draytek Vigor2860 series User Manual page 786

read
reboot
reply
772
-a <0/1>: Set whether to send an e-mail alert when SMS quota
exceeded. (0: no 1: yes)
-c <cycle>: Set the order of today in refresh cycle.
-d <day>: Set the refresh day.
-e <0/1>: Enable or disable SMS Quota Limit function. (0: disable 1:
enable)
-h <hour>: Set the refresh hour.
-m <0/1/2>: Set SMS quota refresh mode. (0: None 1: monthly 2:
periodically)
-n <number>: Set SMS quota. The avaible number is between 1 and
1000000.
-s <0/1>: Set whether to stop sending SMS after SMS quota
exceeded. (0: no 1: yes)
Display information of an SMS in the LTE SIM card by specifying the
index number. Use "all" to display all.
Set settings of Reboot on SMS Message function.
<command> <parameter> | ...
The available commands with parameters are listed below.
[...] means that you can type in several commands in one line.
-a <0/1>: Enable or disable Access Control List. (0: disable 1:
enable)
-e <0/1>: Enable or disable Reboot on SMS Message function. (0:
disable 1: enable)
-p <password>: Set the Password / PIN. This setting is necessary if
this function is enabled.
-x <number>: Set the first phone number in Access Control List.
-y <number>: Set the second phone number in Access Control List.
-z <number>: Set the third phone number in Access Control List.
Set settings of Reply with Router Status Message function.
<command> <parameter> | ...
The available commands with parameters are listed below.
[...] means that you can type in several commands in one line.
-a <0/1>: Enable or disable Access Control List. (0: disable 1:
enable)
-c <0/1>: Set whether to reply with MAC address. (0: no 1: yes)
-e <0/1>: Enable or disable Reboot on SMS Message function. (0:
disable 1: enable)
-f <0/1>: Set whether to reply with WAN1 IP address. (0: no 1: yes)
-g <0/1>: Set whether to reply with WAN2 IP address. (0: no 1: yes)
-h <0/1>: Set whether to reply with LTE WAN IP address. (0: no 1:
yes)
-i <0/1>: Set whether to reply with WAN4 IP address. (0: no 1: yes)
-j <0/1>: Set whether to reply with WAN1 data usage. (0: no 1: yes)
-k <0/1>: Set whether to reply with WAN2 data usage. (0: no 1: yes)
-l <0/1>: Set whether to reply with LTE WAN data usage. (0: no 1:
yes)
-m <0/1>: Set whether to reply with WAN4 data usage. (0: no 1: yes)
-n <0/1>: Set whether to reply with Router name. (0: no 1: yes)
-p <password>: Set the Password / PIN. This setting is necessary if
this function is enabled.
-u <0/1>: Set whether to reply with Router system uptime. (0: no 1:
yes)
-v <0/1>: Set whether to reply with Router firmware version. (0: no
1: yes)
Vigor2860 Series User's Guide