GE Voluson S6 Basic User Manual page 348

Volume Mode
9.12.5.6 Threshold Volume
9.12.5.7 Vocal Measurement Display
9-130
2. Select the desired Render Mode (e.g., Inversion).
If you have select [Vocal Surface] Render Mode you can change the display
of the Shell Geometry among [Skin] or [Wire Mesh].
Select this key to change the "Surface Color" of the Shell Geometry.
After volume calculation via the VOCAL program, it is possible to display an automatically
calculated Threshold volume.
Select the [Threshold Volume] key in the Vocal menu.
The screen shows the calculated Threshold volume (according to the monitor display).
Monitor display (e.g., Hydronephrosis)
Select the [Exit] key to exit the Threshold Volume function.
The layout and position of the display of the VOCAL results has to be the same as selected in
"Measurement Setup" – "Global Parameters" in
11-109 ) . If result position is mode dependent the settings for 2D apply to VOCAL as well.
If the measurement function is activated in VOCAL, the
reminds the user that UNINTENDED USE of this feature could lead to measurement
inaccuracy (below accuracy mentioned in
page 11-23 ). This symbol will also be shown on the patient report (in the report header), if
the performed VOCAL measurements are stored in the report. (see:
on page 11-101 ).
Worksheet Functions'
(chapter 'The Measure Setup Pages' on page
symbol appears. This symbol
chapter 'Measurement Accuracy of the System' on
chapter 'Basic Patient
Voluson® S6/S8 Basic User Manual
5433669-100 Revision 4