Hardware And Software Requirements - Siemens SIMATIC S7-1500 System Manual

6.2

Hardware and software requirements

Introduction
Please note the following requirements for use of the SIMATIC Drive Controller in a SINAMICS
drive system.
Hardware requirements
Table 6- 1
Component
SIMATIC Drive Control-
ler
PROFINET
PROFIBUS
24 V DC power supply
SINAMICS S120 system
components
SIMATIC Drive Controller
System Manual, 11/2023, A5E46600094-AD
Hardware requirements
Property/requirement
The SIMATIC Drive Controller is available in various performance classes.
• CPU 1504D TF (small to mid-range applications)
• CPU 1507D TF (high-performance applications)
What performance class you require depends on your specific automation
and Motion Control solution requirements. You can find a summary of the
main performance features of the Drive Controller in Comparison of SIMATIC
Drive Controller versions (Page 58).
Note the following requirements for operation of a SIMATIC Drive Controller
as a bus device:
PROFINET
• The integrated PROFINET interface of the CPU is configured using STEP 7
(IP address and device name configured).
• The CPU is connected to the subnet. See the PROFINET Function Manual
(https://support.industry.siemens.com/cs/ww/en/view/49948856)
For the rapid exchange of control data between the SIMATIC Drive Controller
and drive components connected over PROFINET (for example SINAMICS
S120, SINAMICS S210), the PROFINET IO network must be configured as
isochronous.
PROFIBUS DP
• The integrated PROFIBUS interface of the CPU is configured using STEP 7
(node address and bus parameters configured).
• The CPU is connected to the subnet.
• The terminating resistors at the segment boundaries are on. See the
PROFIBUS Function Manual
(https://support.industry.siemens.com/cs/ww/en/view/59193579)
Electronics power supply for the SIMATIC Drive Controller.
Power supply units for the 24 V DC supply must supply safety extra-low volt-
age in accordance with IEC 61131-2 or IEC 61010-2-201.
Devices from the SITOP family, for example, can be used.
You can find information on the 24 V power supply specifications in Power
supply (Page 112).
Please note the installation information in the SINAMICS S120 manuals and
the "Rules for wiring with DRIVE-CLiQ" in the SINAMICS S120 Function Manu-
al (https://support.industry.siemens.com/cs/ww/en/view/109781535).
Application planning
6.2 Hardware and software requirements
103