Table of Contents
Advertisement
20
en | Installing Roof Parapet and Pipe Mounts
2.3
Mount Power Supply Box
Before mounting the Power Supply Box decide if you will be wiring the box through the holes
in the bottom or back of the box. If wiring the box through the back, move the two (2) seal
plugs to the bottom holes before mounting.
NOTICE! Use 3/4-inch NPS (20-mm) fittings for the holes on the bottom and back of the box.
i
Use 1/2-inch NPS (15-mm) fittings for the side holes. See Figure 2.6 on page 25.
Fig. 2.2 Wall Mount Power Supply
1.
Use the wall mount template supplied in the packaging box to locate the four (4) mount-
ing holes for the Power Supply Box.
2.
Drill four (4) holes for the mounting anchors. If installing outdoor, apply a weatherproof
sealant around each hole at the mounting surface.
3.
Place the Power Supply Box into its Trim Skirt.
4.
Secure the Power Supply Box to the wall using four (4) corrosion-resistant stainless steel
studs (not included).
WARNING! A stud diameter of 6.4-mm (1/4-inch) or 8-mm (5/16-inch), able to withstand a
!
120 kg (265 lb) pull-out force is recommended.
5.
Attach the 3/4-inch (20-mm) watertight pipe fittings (not supplied) to the holes of the
Power Supply Box through which you will run the power, video, and control data wires.
F01U010921 | 1.0 | 2006.10
Installation Manual
AutoDome Modular Camera System
Bosch Security Systems, Inc.
Advertisement
Table of Contents
