S-Series Card Reader - Bosch Access Easy Controller Hardware Manual

Access Easy Controller
6.5

S-Series Card Reader

1.
2.
3.
4.
Bosch Security Systems
Configure the reader for card and PIN operation, please refer to the Access Easy Control-
ler Software User Manual for detail in enabling the card and PIN operation.
Present a card to the reader.
Result: The green LED should turns off briefly and the reader should sound a short beep.
This indicates that the reader recognized the card.
The reader should then begin a slow flash of the green indicating that the PIN code
should be entered.
Enter the card's PIN code by slowly pressing the numeric keys on the reader's keypad.
After entering the last digit, press the Enter key to complete PIN entry.
Result: An audible beep will be heard after each key is pressed.
Depending on the setup of the controller database for the card used in the previous step,
one of two events will occur within a second after pressing the Enter key in the previous
step. Note that either response indicates that the reader and keypad are working.
– If the card is configured to allow access through the reader and the correct PIN code
was entered, then the green LED will turns off for a few seconds indicating that
access has been granted.
– Or, if the database has not yet been fully configured, then the green LED will flash
rapidly for two of three seconds indicating that access has been denied.
Hardware Manual
How to Install Reader and Field Devices | en 43
Ver 2.0.0 | 2006.07