Entry Operation; Using Card + Pin Mode On A Keypad Reader; Using Keypad In The Enable Keypad Only Operation Mode - Bosch Access Easy Controller Hardware Manual

162 en | Card Reader Keypad Functions
4.
5.
6.
7.
21.2

Entry Operation

The following sections highlight the various means to enter and exit a controlled area using
the keypad. These functions MUST be enabled in the Card Reader parameter setting before it
could be used. Refer to the AEC Software manual for details in enabling these functions.
21.2.1

Using Card + PIN mode on a Keypad Reader

To gain access, follow the procedures: -
1.
2.
21.2.2

Using Keypad in the Enable Keypad Only Operation mode

If the Enable Keypad Only Operation mode is activated, all users can either gain access by pre-
senting card or by entering their card number using the
set in Card and PIN operation AND the door required PIN code for entry, user(s) has to enter
their card number followed by their assigned PIN code before access is granted.
Manual Card Entry without PIN code
1.
Ver 2.0.0 | 2006.07
The key is used in order for the system to capture the clock-out times of the card-
holders (employees only).
The or key is used to terminate an entry.
The or key is used to cancel/quit any changes made.
The key is used together with an arming card to arm alarm zones.
Present the card to the Reader, the LED flash at a slow rate for the duration as depicted
in the Reader's Keypad Timeout field.
Enter your PIN code (followed by the
PIN code is valid, pull the door to get in. Otherwise, the LED will flash at a fast rate, indi-
cating a wrong PIN code.
First, press the key, The LED flash continuously at a slow rate for the duration as
depicted in the Keypad Timeout field.
Hardware Manual
or key, if it is less than 7 digits). If the
key. However, if the card(s) is
Access Easy Controller
Bosch Security Systems