Figure 8-50 Transceiver Shield Pressure-Connecting Pin Into Tap Body; Figure 8-51 Loosing The Cap Screw Of The Transceiver Tap Frame; Figure 8-52 Installing The Transceiver Tap Frame And Tap Body - Hitachi S10mini User Manual

① Insert the shield pressure-connecting pins into the tap body.

Figure 8-50 Transceiver Shield Pressure-connecting Pin into Tap Body

② Loosen the cap screw to the extent that it does not come off.

Figure 8-51 Loosing the Cap Screw of the Transceiver Tap Frame

③ Align the tap body with a 2.5 m intervals mark. Slide the frame into position and
secure it by tightening the cap screw tighten the screw until the gap between the tap body
upper surface and cap screw is reduced to about 1 mm.

Figure 8-52 Installing the Transceiver Tap Frame and Tap Body

With a 2.5 m intervals mark
positioned at the center
8-53
8 APPENDIXES