Setup Ip Address - Hitachi S10mini User Manual

5 USER GUIDE

5.6.10 Setup IP address

Online editing for the S10mini or S10V controller
Function: Set the IP address of the FL.NET module.
For using this function, it is a prerequisite that the PCs is connected to the PC by cable.
Operation: The procedure is shown below.
(1) Select [IP address] from the [Module] menu of the [FL.NET] window or [[S10V] FL.NET]
window.
(2) The [Setup IP address] window is displayed. Enter the IP address and subnet mask.
(3) After completing the setup, click the
controller used is S10V). To cancel the setup, click the
(4) After completing the setup, reset the PCs or display the power OFF/ON request message.
After confirming with the equipment administrator, reset the PCs or turn off and on the power
supply. (For the S10V, the message "It reset PCs.OK?" is displayed. At this time, click the
OK button.)
OK button (or the
5-146
Write button if the type of the
Close button.