8.5.2 10BASE5 components
(1) Transceiver
The transceiver converts a signal flowing along a coaxial cable (yellow cable) to a signal
required for a node or vice versa.
Transceivers to be attached to a coaxial cable must be positioned at spacing intervals of an
integer multiple of 2.5 m. Ensure that they are installed over the markings on a coaxial cable.
Before attaching transceivers to a coaxial cable, switch off the node and transceiver power
supplies. If you make transceiver connections with the power applied, an electrical short may
occur.
Ensure that the employed transceivers comply with the IEEE 802.3 standard.
Provide an extra length in consideration of
transceiver cable bend radius (minimum
bend radius: 80 mm).
TR label
Transceiver (tap type)
Figure 8-23 Transceiver and Transceiver Cable (AUI)
Secure with wire ties or like clamps
(at about 2 places).
Figure 8-22 Transceiver Overview
Transceiver cable (AUI cable)
Retainer
8-35
Transceiver cable
Coaxial cable
Transceiver (Tap-type)
Coaxial cable (yellow cable)
8 APPENDIXES