Siemens SINUMERIK Series Operating Manual page 555

Parameter
αC
(for ShopMill program)
Hirth joint
Tool
Preferred direction (for
ShopMill program)
P
G
Milling
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0
Description
Rotational position for a pole position
● Round to the next Hirth joint
● Round up to Hirth joint
● Round down to Hirth joint
Note:
For machines with a Hirth joint
Tool tip when swiveling
● Tracking
The position of the tool tip is maintained during swiveling.
● No tracking
The position of the tool tip is not maintained during swiveling.
Preferred direction of the swivel axis for several possible alignments of the machine
● Thread pitch in mm/revolution
● Thread pitch in inch/revolution
● Thread turns per inch
● Thread pitch in MODULUS
Change in thread pitch per revolution - (only for P = mm/rev or in/rev)
G = 0: The thread pitch P does not change.
G > 0: The thread pitch P increases by the value G per revolution.
G < 0: The thread pitch P decreases by the value G per revolution.
If the start and end pitch of the thread are known, the pitch change to be programmed
can be calculated as follows:
|P - P |
2 2
e
G = ----------------- [mm/rev
2 * Z
1
The meanings are as follows:
P : End pitch of thread [mm/rev]
e
P: Start pitch of thread [mm/rev]
Z : Thread length [mm]
1
A larger pitch results in a larger distance between the thread turns on the workpiece.
Programming technological functions (cycles)
]
2
10.4 Turning - milling/turning machine
Unit
Degrees
mm/rev
in/rev
turns/"
MODULUS
mm/rev
2
555