Siemens SINUMERIK Series Operating Manual page 224

Hide thumbs Also See for SINUMERIK Series:

Table of Contents

Machining the workpiece

6.10 Editing a program

Saving machining times Specifies how the machining times determined are processed.

Display cycles as ma‐

chining step

Highlight selected G

code commands

All entries that you make here are effective immediately.

You have opened a program in the editor.

A subdirectory with the name "GEN_DATA.WPD" is created in the

directory of the part program. There, the machining times determined are

saved in an ini file together with the name of the program. The machining

times are displayed again when the program or job list are reloaded.

The machining times that have been determined are only displayed in the

● Yes: The cycle calls in the G code programs are displayed as plain text.

● No: The cycle calls in the G code programs are displayed in the NC syntax.

Defines the display of G code commands.

All G code commands are displayed in the standard color.

Selected G code commands or keywords are highlighted in color. Define

the rules for the color assignment in the sleditorwidget.ini configuration

Note: Please observe the information provided by the machine

manufacturer.

This setting also has an effect on the current block display.

Defines the font size for the editor and the display of the program sequence.

If you open a second program, then the smaller font size is automatically

● normal (16) - character height in pixels

Standard font size that is displayed with the appropriate screen

● small (14) - character height in pixels

More content is displayed in the editor.

This setting also has an effect on the current block display.

Operating Manual, 08/2018, 6FC5398-7CP41-0BA0